DS2413 1-Wire Dual I/O Chip

1-Wire Dual Reed contact module, board Unassembled printed circuit board for the assembly of a 1-Wire dual reed contact module.With the 1-Wire Dual Reed Contact Sensor Module two independent reed contacts (magnetic switches) can be monitored.The sensor can be used, for example, to monitor a window, door or garage door. 1-Wire interface DS2413 Dual I/O Dimensions 85,8x30,5mm Connection Screw terminals for 1-Wire bus and input voltage (up to 2.5qmm possible) Supply voltage 1-Wire Bus with 5V and 12V Power consumption 5V approx. 1mA, 12V approx. 5mA (both inputs active) Isolation Inputs electrically connected with 1-Wire bus Installation intended for top hat rail housing (switch cabinet installation) Scope of delivery Unassembled board in industrial quality without components or housing.Building instructions per download Cable length between sensor and module It is recommended to use max. 10m cable length. Labelling CE Protection class III Note: SMD components must be soldered on the board

1-Wire Dual Digital Input, Board Unassembled printed circuit board for the construction of a 1-Wire digital input. With the 1-Wire dual digital input module two inputs can be monitored independently of each other. A pump or lamp can be monitored as an example. The inputs are connected in parallel to the consumer to be monitored. The dual input module is designed for three variants:- 230V AC voltage - 24V DC voltage - 5V DC voltageConnection: screw terminals for 1-wire bus and input voltageSupply voltage: 1-Wire bus with 5V and 12VCurrent consumption: 5V approx.1mA, 12V approx. 5mA (both inputs active)Installation: Designed for control cabinet installation (top hat rail)Protection class:  IIAssessories: Top hat rail housing (HUT 2)Scope of delivery: Unassembled board in industrial quality without components or housing. Building instructions per downloadNote: Small SMD components must be soldered on the board.