Wall bracket for wind sensor Pro 100

Wind sensor Pro 200 with heating With the compact and professional wind sensor Pro 200, the current wind speed can be recorded and, e.g. in the event of gusts of wind, it can provide information via the system control for retracting an awning or raising roller shutters or slats. The wind sensor Pro 200 is an optimal environmental sensor for recording wind speed for weather recording. For operation in winter the wind sensor Pro 200 is equipped with a heater. This prevents icing and thus a failure of the wind sensor. All bearings and screws are made of weather-resistant stainless steel and are therefore suitable for professional use in weather stations. Via the S0 interface (pulse output) pulses are output depending on the wind speed. 4 pulses are emitted per revolution. The wind sensor Pro 200 has a pulse output and is designed for connection to the 1-Wire Dual S0 counter module (Art. No. 11211). It is weatherproof and has an approx. 3 meter long connection cable. A mast holder, wall bracket and mounting masts are available as accessories. Application Protection of awnings, roller shutters and blinds / slats by gusts of wind Recording of the wind speed for weather data acquisition Assembly Mounting on 50mm mast (antenna mast) Wall or roof bracket Flat roof mast Cable length max. 10m to S0 counter Measuring range 0 - 50m/s (0 - 180 Km/s) Output signal sensor 4 pulses per m/s Electrical values Heating: 24 V AC or DC approx. 0.15W S0 interface (reed contact, normally open contact) 4 pulses per revolution 1 pulse corresponds to 0.25m/s Connection approx. 3m cable, 4-wire Evaluation Pulse output e.g. for 1-Wire S0 counter 11211 See connection example (Download) Dimensions approx. 210 mm x 80mm (height x width) Wind turbine Ø 160 mm Accessories Pole mount, wall bracket, pole for flat roof Scope of delivery Wind sensor without mounting bracket

Sensor holder for mast mounting with clamp Mounting set for rain detector or 1-Wire solar brightness and temperature sensor Mast mounting (1/2' tube) Optimum drip angle Corrosion resistant aluminium Simple and stable construction Application pole mounting for - rain sensor or - 1-Wire solar, brightness and temperature sensor Material Aluminium, 2 mm Drainage angle 45 ° Scope of delivery Mast clamps, screws and dowels Without sensors