Offer PriceWith the Dual Dimmer 1 you can dim and switch lamps very gently. The brightness of the connected lamps can be controlled or switched on/off by the touch dimmer function in the living room (extension input), by push-buttons on the top of the module and electronically via the 1-Wire interface. For the touch dimmer function any push-button from all switch ranges can be used. The dimming behaviour is always very soft and pleasant. The brightness can be changed by pressing the living room buttons for a long time, a short press switches on/off. The touch dimmer function works with 12V or 24V DC voltage, which does not cause any disturbance in the living area. This makes the Dual Dimmer 1 ideal for low-radiation areas such as bedrooms and living rooms. With the ESERA-Manual control, you can operate the lighting reliably. Everything works just like in a "normal house", even without smart home control or software. The 1-Wire bus interface is available for integration into your Smart Home control system. This dimmer can switch and dim dimmable LED lamps, incandescent lamps, high voltage halogen lamps (ohmic loads) as well as low voltage halogen (12V halogen) or fans (inductive loads) with corresponding power. Low voltage halogen lamps may only be operated in conjunction with a wound transformer.For the living room touch dimmer function it is sufficient if the Dual Dimmer 1 is supplied with the 1-Wire bus voltage (12V). This enables a "Smart Home Ready" installation in your building or apartment. This also results in extremely high reliability, as the lighting works when the smart home control is not yet programmed or fails. Function Dimmer with phase control for dimmable LEDs, incandescent lamps, high-voltage halogen lamps or low-voltage halogen lamps via conventional transformersNot suitable for lamps with electronic ballast, energy-saving lamps or fluorescent lamps. Soft start and soft dimming behaviour Storage of the last dimming level Status feedback of the push button interface Dimming levels readable Compatible with all 1-Wire controllers* on the market (*which can send and read standard DS2408 commands) Convenient control and extended functions via ESERA 1-Wire controller / 1-Wire gateway (from firmware 1.18_54) Output 2 dimming channels, (phase control) Output power: max. 460W (460VA), with LED illuminants max. 200W (200VA) and max. 6 LED illuminants Minimum load 6W Suitable for ohmic and inductive loads Manual control / control inputs (digital / binary inputs) 2 x push-button input (conventional control with living space - light buttons) 2 x module top side 1-Wire bus interface (GND, Data, 12V) Push button interface Number: 2 binary / digital inputs Functions: on/off/dimming (Up/Down) 128 dimming levels for very smooth dimming behaviour Soft start and smooth dimmer 10-30V DC voltage, max. 20mA Control current Electrically isolated from 1-Wire bus and dimmer outputs Status readable via data interface Connection Screw terminals for 1-Wire bus and dimming outputs (up to 2.5qmm) Isolation Electrical (galvanic) insulation Outputs to bus and push-button interface Push button interface for the use of any control voltage between 10 - 30VDC 1-wire interface Control and readback based on DS2408 functions 32 dimmer stages for smooth dimming behaviour Data output of the binary/digital inputs (push-button interface) Data output of the dimmer values 3-wire system, GND, Data and 12V Power supply 12VDC (max. 50mA) via 1-Wire interface Installation Designed for control cabinet installation (top hat rail) Dimensions/mounting Top hat rail mounting, 4 TE width, 32 x 90 x 70mm (WxHxD) Scope of delivery Finished module, operating instructions